Kinematics VM-855 — CNC Vertical Machining Center
Our workhorse. Hard-cuts pre-hardened cavities and cores to SPI-A1 finishes in a single setup, with linear-scale feedback holding five-micron repeatability through lights-out cycles.
Capability, Verified
A capability list,
not a brochure.
We are a mould maker first and a machine shop second — since 2023, every tool leaving our floor has been proven to run on presses up to 650 tons, cut by the machines listed below. No subcontracted cutting, no padded numbers.
Chemer Sparking ZNC-CM323Z — Spark Erosion (M.M.T.)
Die-sinking EDM for deep ribs, sharp internal corners, texture burns and cavity re-work — the finishing weapon where rotary cutters physically cannot reach.
Kent Surface Grinder — Precision Plate Finishing
Hydraulic table drive holding plate parallelism to 0.003 mm — mould bases, wear plates and parting lines ready for blue-match.
Phillips Surface Grinder — Heavy Plate Finishing
Our second surface grinder for heavier plate work and liners — the workhorse that keeps bases, slides and wear plates square before assembly.
Tsugami CNC Lathe — Light Duty (Turning)
Turns guide pillars, bushings, ejector components and turned inserts to mirror finishes.
K.B.S Pillar Drilling Machine — Die 3/4″
Dowelling, vent pins, centre taps and tie-down work during bench assembly — the machine that keeps every plate honest relative to the next.
Universal Milling Machine — Manual Knee Mill
Manual universal mill for mould bases, slots and fixtures — the hands-on counterpart to the VMC for one-off jobs and quick repairs.
Machine Registry — Official List
| SR.NO. | Particulars | Qty. |
|---|---|---|
| 01 | CNC Milling “Kinematics” (VM-855)
X-800mm · Y-500mm · Z-500mm Table work area (L × W) 800mm × 500mm · Loading capacity 500 kg |
2 Nos. |
| 02 | Spark Erosion M.M.T.Die-sinking EDM — Chemer ZNC-CM323Z | 1 Nos. |
| 03 | Surface Grinding — KentHydraulic surface grinder for plates & parting lines | 1 Nos. |
| 04 | Surface Grinding — PhillipsHeavy plate finishing, liners & slides | 1 Nos. |
| 05 | LatheLight Duty — Tsugami CNC lathes for pillars, bushings & inserts | 2 Nos. |
| 06 | Drill MachineDie 3/4″ Drill — K.B.S. pillar drill for dowelling & bench work | 1 Nos. |
| 07 | Universal Milling MachineManual knee-type universal mill for bases, slots & fixtures | 1 Nos. |